Results 1 to 4 of 4

Thread: Need to Learn the Basis

  1. #1
      Negima09 is offline
    Guild Applicant
    Join Date
    Nov 2009
    Posts
    1

    Help Need to Learn the Basis

    Hi
    i am trying to create a map on the computer i already have some on paper but come ugly when i scan them. i wish to recreate them and fill them up.
    Yet i have no idea of what programs to use or the basics in creating a map in these programs
    Help would be very appricated and thanks!

  2. #2

  3. #3
      Ascension is offline
    Community Leader Ascension's Avatar
    Join Date
    Jun 2008
    Location
    St. Charles, MO
    Posts
    8,216

    Post

    Check the Software Discussion section. There are a bunch of things that you can use, some that you have to pay for and some that are free.
    If the radiance of a thousand suns was to burst at once into the sky, that would be like the splendor of the Mighty One...I am become Death, the Shatterer of worlds.
    -J. Robert Oppenheimer (father of the atom bomb) alluding to The Bhagavad Gita (Chapter 11, Verse 32)


    My Maps ~ My Brushes ~ My Tutorials ~ My Challenge Maps

  4. #4
    Guild Master Gracious Donor Midgardsormr's Avatar
    Join Date
    Aug 2007
    Location
    Los Angeles, CA
    Posts
    2,401

    Post

    We don't have a scanning guide here yet, as far as I know. I can share what works for me, but perhaps others who have scanned hand-drawn work can give some advice?

    I set my scanner to 600 dpi, 16-bit grayscale (when I can. My home scanner only works at 8-bit, but the ones at school can do 16). I apply a 2 pixel Gaussian blur to the result, then scale down 50%. That usually smooths out the irregularities of the paper and graphite, giving me a 300 dpi image at the original physical size. If it's still too rough, I might rescan at 1200 dpi, blur by 4 pixels and reduce to 25%, but that scan takes a long time.

    The resulting image goes at the top of my layer stack set to the multiply blend mode, so that the white will vanish, leaving whatever colors I paint underneath. I use this technique rather than trying to delete the white because it makes for nicer lines, without that light gray halo you get from the blend between graphite and paper.

    From there, you can use the magic wand to select inside the lines on your top layer. Sometimes it's a good idea to expand your selection by a pixel or two to get it fully beneath the lines, but it depends on the drawing and the size you're working at.

    This method works quite nicely for lines on tracing paper, too, by the way.
    Bryan Ray, visual effects artist
    http://www.bryanray.name

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •