WIP- FT Script development

[Master TMO]

Well, the two Incise Flows I use are as follows:

General Whole World: (modified from the one given in the FT tutorial)
// Tool Incise_flow blur  amount   exponent   effectblend
Tool Incise_flow     1.5    1.5       0.4         0.5


Glaciation Incise Flow: 
// Tool Incise_flow blur   amount   exponent   effectblend
Tool Incise_flow     1.0    0.5       0.2         1.0

From the notes I've found searching the forums, having a lower Exponent value means it follows more riverbeds. So the Glaciation Incise carves more channels, but not as deep, and (theoretically at any rate) less blurred and more sharply defined.

And I don't see anything that allows me to enter a slope for the Basin Fill operations. When I run them from the menus it just processes immediately. And the Script Info file doesn't list any parameters for the commands.

Tool Fill_basins
fill the basins in the surface in the offset channel at the current editing resolution.

Tool Fill_lakes
fill the basins in the surface in the water channel at the current editing resolution.