Just joined up and saw this tutorial and your result looked amazing so I figured I'd give it a go as my first map ^^. The tutorial was extremely easy to follow however I had a bit of a problem that I can't figure out. My brush seems to have left quite a few marks throughout the map and I was wondering if you knew how to avoid this problem.
Looks great!...other than those strokesIt looks like you have the brush properties set to something other than normal. First click on the brush tool, then at the top you will see the word "Mode" in the box next to that, make sure it says Normal and not something like multiply or difference. It could be that you did the airbrushing on it's own layer and never merged it down onto the clouds layer, thus you're getting some artifacts from that. If that's not it lemme know and I'll see if I can replicate this effect (might take me a while since I'll be experimenting a lot to find the needle in the haystack).
If the radiance of a thousand suns was to burst at once into the sky, that would be like the splendor of the Mighty One...I am become Death, the Shatterer of worlds.
-J. Robert Oppenheimer (father of the atom bomb) alluding to The Bhagavad Gita (Chapter 11, Verse 32)
My Maps ~ My Brushes ~ My Tutorials ~ My Challenge Maps
It looks like that fixed it, I had it set to normal before but I had an airbrush button pressed. I just tried again with the airbrush button not on and it didn't leave the marks as far as I can tell with just doing up to the land step. ^^
Thanks a ton
No prob, man. Just here to help
If the radiance of a thousand suns was to burst at once into the sky, that would be like the splendor of the Mighty One...I am become Death, the Shatterer of worlds.
-J. Robert Oppenheimer (father of the atom bomb) alluding to The Bhagavad Gita (Chapter 11, Verse 32)
My Maps ~ My Brushes ~ My Tutorials ~ My Challenge Maps
Posting Permissions
Reply With Quote