I have to agree about the stairs, but I'm not sure how to make them stand out without going outside of CC3 to do so. While I have access to Adobe and Corel I was trying to remain completely faithful to the CC3 engine.

I can create a new stair .png and import it. If I were to do so, what changes should I make? Since this is topdown and not isometric it's difficult (IMO) to show an elevation change. Should the stairs be wide at the top and narrower at the bottom? It's only a difference of about 10 feet from floor to ceiling so I don't think perspective should be greatly skewed.

I'm completely open to suggestions.

Thanks again.