Page 1 of 2 12 LastLast
Results 1 to 10 of 13

Thread: City of Fortune (reality check request)

  1. #1

    Wip City of Fortune (reality check request)

    This was intended for the world/regional map forum.

    I'm looking to get a reality check on the rough draft of my map. I tried to make sense of things, but don't have a deep understanding of geography (yet.)

    Forgive the map. It's 30 minutes of scribbling on printer paper at work followed by a rushed scan through a crappy work printer. I do like the stippled jungles and shaded mountains though. Some version of those may make the final map.

    The whole area is tropical. The stippled blobs are dense jungle. The "wood block" blobs are lakes. Most of the lakes are in the wetland/swamp region at the base of the mountains. A desert sits in the upper right corner, trapped between the shown mountain range and another on the other side, and the edge of a large savanna can be seen on the bottom right. I'm assuming the map is about a thousand miles across (800 from the delta to the right side). The large river, like Nile or Amazon big, flows east to west. The prevailing winds go west to east. It takes about 8 days by sail to get from the delta to the right side of the map. 10 days on the current to go the other way. I know nothing about boats, so I could be so far off on my times/scale.

    The city the campaign is named after sits on the delta (swiped from RobA because it's a cool concept and I got nothin' better planned.) That could screw with my plans for underground catacombs and an eventual assault from the underdark...

    I'm avoiding doing a "world map" as I want to work up regions as I get ideas. Fortune is a world center of trade, brdiging the gap between the often strange and isolated cultures of this (the largest) continent and the more familiar european continent that the founders of Fortune hail frome; as well as other continents and city-states around the world, and I'm going very much for that cobbled together roman empire feel within the city with strange new cultures constantly integrating.

    Other villages and towns will be added in the next revision.

    Comments and criticisms wanted. I'll take as much feedback and assistance as anyone cares to offer.
    Attached Images Attached Images
    Last edited by Aristotle; 06-20-2008 at 04:37 PM.

  2. #2

    Post

    It has a lot that I like about it. A good basis to be sure. I assume Fortune will go in the delta on the west side of the map?


    My first comment would be that Deltas don't generally stick out like petals from the shore unless the water is very shallow or there has been some peculiar erosion. Deltas are the fertile depositories of silt carried down the length of a river. You may want to bring the west coast out a bit to make the delta more a gentle swell rather than an appendage.

    The second comment is the river. It is possible that a river is that straight but usually they have more bends to them. Rivers are constantly undercutting their own paths and shifting as the soil is carried away. The path you describe would be possible through a large uniform body of sand or silt but it would be interrupted by rocks and land variation, perhaps even prevailing winds.


    I like the map. If you're going to borrow ideas from someone here ROBA is a good choice .

    I'd love to see it with some colour because that would make it much more clear.


    Sigurd

  3. #3

    Default

    I think it's ready for colouring...the only bit that stands out for me is the 'glove like' appearance of the river delta. If you're doing it by hand the mountains could be a little less uniform, I guess, but it looks pretty good to me.

  4. #4

    Post

    Agreed. The delta is a little more pronounced than it should be, especially at this scale. I'll research that. I'll look at twisting the river up a bit more in the next draft. I think my real problem there was just that it was my first line on the paper and I wasn't really loose yet.

  5. #5

    Post

    You might also want to think about what is going on geologically with the river running between two mountain ranges. Normally, I'd expect there to be higher land linking the two ranges, which would prevent the river from flowing through there.

    That isn't to say that it can't happen, but it probably means that there is something unusual going on. Look up the recent thread about using tectonics to create a world map: http://www.cartographersguild.com/showthread.php?t=2238
    It's got some solid info on how mountain ranges are formed.
    Bryan Ray, visual effects artist
    http://www.bryanray.name

  6. #6

    Post

    Moved.

    Also, I've attached a snap from googlemaps showing the terrain around the Mackenzie River in Canada at about the same scale as your map:
    2008-06-20_184355.png

    This should give you a good idea of the shape a river and delta can have at this scale. The Mackenzie's delta is HUGE...over 100 miles across. I'd suspect this is because tremendous volumes of water came from the melting glaciers, carrying an large amount of material to the ocean.

    With respect to the location (between two mountain ranges) remember to think in terms of watersheds. I'll reference the Mackenzie river again:
    (image from Wikipedia - I added the blue square which shows the location of the above map)
    temp.png

    You can see that every rain drop that lands in this zone in this zone eventually flow into the river. The boundaries of the watershed are ridge lines that have one watershed one one side, and a different one on the other.

    As stated by others, the geography would need some explaining... but at this scale, it is not impossible, though the two ranges should probably be further apart.

    -Rob A>

  7. #7
    Community Leader Facebook Connected Ascension's Avatar
    Join Date
    Jun 2008
    Location
    St. Charles, Missouri, United States
    Posts
    8,392

    Post

    First, it's great to see (er read about) all of the detail you have thought of when thinking about how you want to make your map, certainly more detail than I normally think about. Second, the tributaries are all snakey so the main river being more straight was just probably something overlooked (I do it too). Third, I agree, push the mountains apart a bit more, or lower them as you near the river. All in all though, with a couple of minor tweaks, it's ready for color. Good job and keep it up.

    My 2 cents (what's the exchange rate these days for cents to euros?)

  8. #8
    Community Leader NeonKnight's Avatar
    Join Date
    Aug 2007
    Location
    Surrey, Canada, EH!
    Posts
    5,051

    Post

    Not much I can say beyound what has already been said. Nice map too.!
    Daniel the Neon Knight: Campaign Cartographer User

    Never use a big word when a diminutive one will suffice!

    Any questions on CC3? Post them with CC3 in the Subject Line!
    MY 'FAMOUS' CC3 MAPS: Thunderspire; Pyramid of Shadows; King of the Trollhaunt Warrens; Demon Queen's Enclave

  9. #9

    Post

    Not much of an update, but...

    <deletion: long winded paragraph where I propose increasing my map to 10k sq. miles.>
    <addition: So I did a little more research and it appears I am using the term "square miles" all wrong. 800 miles from side to side isn't an 800 square mile map. It'd be... 640,000 square miles? So, a "bit" larger than my proposed increase to 10k. Excuse me while I go back to 5th grade and pay a little attention this time around.>

    Also. I've been messing with some tutorials and am torn between the 'hand drawn' look and the more realistic look some of you have perfected. I've seen some amazing examples of both. I might have to save my coastlines and try my hand at each. I need coastlines first though, so I spent all night last evening playing with RobA's 'not so random coastlines' tutorial. I may have fallen into a (common?) trap of generating dozens of coastlines looking for the "right one."

    I did find, given that the majority of my map is land, that working in reverse (black land and white water) tended to give me better lines. That might just be me though. I messed around with using different levels of blurring on my coastline and large lakes, and even rendering small selections with different sorts of clouds (i.e. normal clouds for the coast and difference clouds for the wetlands to create several smaller interconnected lakes). I also noticed that I could adjust Threshold on a selection, so I could break-up or solidify specific section of my map. I didn't get much further than that, but it was a fun night even if not very productive.
    Last edited by Aristotle; 06-24-2008 at 12:11 PM.

  10. #10
    Community Leader jfrazierjr's Avatar
    Join Date
    Oct 2007
    Location
    Apex, NC USA
    Posts
    3,057

    Post

    Quote Originally Posted by Aristotle View Post
    Not much of an update, but...

    <deletion: long winded paragraph where I propose increasing my map to 10k sq. miles.>
    <addition: So I did a little more research and it appears I am using the term "square miles" all wrong. 800 miles from side to side isn't an 800 square mile map. It'd be... 640,000 square miles? So, a "bit" larger than my proposed increase to 10k. Excuse me while I go back to 5th grade and pay a little attention this time around.>
    Heh.. reminds me of the that show here in the US "Are you smarter than a 5th grader?" Of course, I think they just find the smartest 5th graders they can rather than the "average" ones as many of them are way smarter than the tests scores indicate (at least in my area of the US)


    Quote Originally Posted by Aristotle View Post
    Also. I've been messing with some tutorials and am torn between the 'hand drawn' look and the more realistic look some of you have perfected. I've seen some amazing examples of both. I might have to save my coastlines and try my hand at each.
    Can you point to samples of the different ones you want to possibly emulate as I am not quite sure what you mean.



    Quote Originally Posted by Aristotle View Post
    I did find, given that the majority of my map is land, that working in reverse (black land and white water) tended to give me better lines. That might just be me though. I messed around with using different levels of blurring on my coastline and large lakes, and even rendering small selections with different sorts of clouds (i.e. normal clouds for the coast and difference clouds for the wetlands to create several smaller interconnected lakes). I also noticed that I could adjust Threshold on a selection, so I could break-up or solidify specific section of my map. I didn't get much further than that, but it was a fun night even if not very productive.
    Yep, threshold is a wonderful thing for creating layer masks! I have played a bit with it to try to get "spotty" forests, with some more nature (mostly smallish) clearings and I think it works very well.

    Joe
    My Finished Maps
    Works in Progress(or abandoned tests)
    My Tutorials:
    Explanation of Layer Masks in GIMP
    How to create ISO Mountains in GIMP/PS using the Smudge tool
    ----------------------------------------------------------
    Unless otherwise stated by me in the post, all work is licensed under a Creative Commons Attribution-Noncommercial 3.0 United States License.

Page 1 of 2 12 LastLast

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •